Yamaha YZF R125 Forums banner
1 - 20 of 44 Posts

·
Registered
Joined
·
361 Posts
Discussion Starter · #1 ·
I've just attempted removing the nose cone, and i've got off all the bolts/screws i can see (circled in red). I'm not really sure where to go next as i don't want to start stripping off bits unless i have to so if anyone can point me in the right direction it would be great ;)
 

Attachments

·
Registered
Joined
·
2,197 Posts
iv never taken mine off befor!
but i think there is a screw at the bottom of the screen.
but i think uv got all the rest!
 

·
Administrator
Joined
·
10,703 Posts
not too hard
just have to take your time
 

·
Administrator
Joined
·
10,703 Posts
the second pic there is more and under the clock there is some screw
 

·
Registered
Joined
·
361 Posts
Discussion Starter · #6 ·
the second pic there is more and under the clock there is some screw
Just couldnt find a pic on the internet of the second view with all the bolts but i got all the ones that are there apart from the one behind the clock. Will investigate cheers.
 

·
Administrator
Joined
·
10,703 Posts
i was looking i couldnt so i just take all the screw and bolts i could fine on the front end
 

·
Premium Member
Joined
·
5,218 Posts
Yeah, I have had to remove all my panels and sprayed them.
What's up?
 

·
Registered
Joined
·
361 Posts
Discussion Starter · #19 ·
Yeah, I have had to remove all my panels and sprayed them.
What's up?
I'm just trying to figure out exactly what screws and allen bolts need to come off so that i can remove it. At the moment the mount for one of the mirrors is stuck on due to a stripped bolt but if i knew what screws had to come off then at least i would know its just the mirror mount that needs to go for me to get it off.

I'm also assuming it needs a little of bit of forcing to come off?
 

·
Premium Member
Joined
·
5,218 Posts
Not so much forcing... just jiggling about.

There is one screw under the very tip of the nose...
The visible ones on the top around the dials etc.

And the mirrors of course. Other than that, I really cannot think of any others :S

There may be a couple on the inside, but I don't think so...
The whole thing should just quite easily come off (headlights and all).

There MIGHT be one on the actual clock mount, but I cannot remember if this one is for removing the nose cone, I don't think it is...
 
1 - 20 of 44 Posts
Top