Yamaha YZF R125 Forums banner
1 - 13 of 13 Posts

·
Registered
Joined
·
2,189 Posts
Discussion Starter · #1 ·
i was thinking of fitting paddock stand boobing but i dont want the offset ones as i wanna be able to take the back wheel off.
iv got a cup paddock stand but it just doesnt feel safe!
what do i have to do to fit them?
it it just a case of drilling and tapin them?
cheers andy!
 

·
Premium Member
Joined
·
10,566 Posts
MrAndy979 said:
i was thinking of fitting paddock stand boobing but i dont want the offset ones as i wanna be able to take the back wheel off.
iv got a cup paddock stand but it just doesnt feel safe!
what do i have to do to fit them?
it it just a case of drilling and tapin them?
cheers andy!
That's is not hard to do Yamaha use 6m you will need 5m metal drill bit and 6m taping tool it's took me 20mins tops to do my one with my mate
 

·
Premium Member
Joined
·
5,090 Posts
That's is not hard to do Yamaha use 6m you will need 5m metal drill bit and 6m taping tool it's took me 20mins tops to do my one with my mate
Want to write up a quick guide please?
 
  • Like
Reactions: MrAndy979
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top